Kernel-4.18.0-80.el8_socfpga-dwmac

Altera SOCFPGA SoC DWMAC controller

This is a variant of the dwmac/stmmac driver an inherits all descriptions
present in Documentation/devicetree/bindings/net/stmmac.txt.

The device node has additional properties:

Required properties:

  • compatible : Should contain “altr,socfpga-stmmac” along with
       "snps,dwmac" and any applicable more detailed
       designware version numbers documented in stmmac.txt
    
  • altr,sysmgr-syscon : Should be the phandle to the system manager node that
    encompasses the glue register, the register offset, and the register shift.
  • altr,f2h_ptp_ref_clk use f2h_ptp_ref_clk instead of default eosc1 clock
    for ptp ref clk. This affects all emacs as the clock is common.

Optional properties:
altr,emac-splitter: Should be the phandle to the emac splitter soft IP node if
DWMAC controller is connected emac splitter.
phy-mode: The phy mode the ethernet operates in
altr,sgmii-to-sgmii-converter: phandle to the TSE SGMII converter

This device node has additional phandle dependency, the sgmii converter:

Required properties:

  • compatible : Should be altr,gmii-to-sgmii-2.0
  • reg-names : Should be “eth_tse_control_port”

Example:

gmii_to_sgmii_converter: phy@100000240 {
compatible = “altr,gmii-to-sgmii-2.0”;
reg = <0x00000001 0x00000240 0x00000008>,
<0x00000001 0x00000200 0x00000040>;
reg-names = “eth_tse_control_port”;
clocks = <&sgmii_1_clk_0 &emac1 1 &sgmii_clk_125 &sgmii_clk_125>;
clock-names = “tse_pcs_ref_clk_clock_connection”, “tse_rx_cdr_refclk”;
};

gmac0: ethernet@ff700000 {
compatible = “altr,socfpga-stmmac”, “snps,dwmac-3.70a”, “snps,dwmac”;
altr,sysmgr-syscon = <&sysmgr 0x60 0>;
reg = <0xff700000 0x2000>;
interrupts = <0 115 4>;
interrupt-names = “macirq”;
mac-address = [00 00 00 00 00 00];/* Filled in by U-Boot */
clocks = <&emac_0_clk>;
clock-names = “stmmaceth”;
phy-mode = “sgmii”;
altr,gmii-to-sgmii-converter = <&gmii_to_sgmii_converter>;
};