Kernel-4.18.0-80.el8_nvidia,tegra210-car

NVIDIA Tegra210 Clock And Reset Controller

This binding uses the common clock binding:
Documentation/devicetree/bindings/clock/clock-bindings.txt

The CAR (Clock And Reset) Controller on Tegra is the HW module responsible
for muxing and gating Tegra’s clocks, and setting their rates.

Required properties :

  • compatible : Should be “nvidia,tegra210-car”
  • reg : Should contain CAR registers location and length
  • clocks : Should contain phandle and clock specifiers for two clocks:
    the 32 KHz “32k_in”.
  • #clock-cells : Should be 1.
    In clock consumers, this cell represents the clock ID exposed by the
    CAR. The assignments may be found in header file
    <dt-bindings/clock/tegra210-car.h>.
  • #reset-cells : Should be 1.
    In clock consumers, this cell represents the bit number in the CAR’s
    array of CLK_RST_CONTROLLER_RST_DEVICES_* registers.

Example SoC include file:

/ {
tegra_car: clock {
compatible = “nvidia,tegra210-car”;
reg = <0x60006000 0x1000>;
#clock-cells = <1>;
#reset-cells = <1>;
};

usb@c5004000 {
    clocks = <&tegra_car TEGRA210_CLK_USB2>;
};

};

Example board file:

/ {
clocks {
compatible = “simple-bus”;
#address-cells = <1>;
#size-cells = <0>;

    clk_32k: clock@1 {
        compatible = "fixed-clock";
        reg = <1>;
        #clock-cells = <0>;
        clock-frequency = <32768>;
    };
};

&tegra_car {
    clocks = <&clk_32k>;
};

};