Kernel-3.10.0-957.el7_usb3503

SMSC USB3503 High-Speed Hub Controller

Required properties:

  • compatible: Should be “smsc,usb3503” or “smsc,usb3503a”.

Optional properties:

  • reg: Specifies the i2c slave address, it is required and should be 0x08
     if I2C is used.
    
  • connect-gpios: Should specify GPIO for connect.
  • disabled-ports: Should specify the ports unused.
    ‘1’ or ‘2’ or ‘3’ are availe for this property to describe the port
    number. 1~3 property values are possible to be desribed.
    Do not describe this property if all ports have to be enabled.
  • intn-gpios: Should specify GPIO for interrupt.
  • reset-gpios: Should specify GPIO for reset.
  • initial-mode: Should specify initial mode.
              (1 for HUB mode, 2 for STANDBY mode)
    
  • refclk: Clock used for driving REFCLK signal (optional, if not provided
    the driver assumes that clock signal is always available, its
    rate is specified by REF_SEL pins and a value from the primary
    reference clock frequencies table is used)
  • refclk-frequency: Frequency of the REFCLK signal as defined by REF_SEL
    pins (optional, if not provided, driver will not set rate of the
    REFCLK signal and assume that a value from the primary reference
    clock frequencies table is used)

Examples:
usb3503@08 {
compatible = “smsc,usb3503”;
reg = <0x08>;
connect-gpios = <&gpx3 0 1>;
disabled-ports = <2 3>;
intn-gpios = <&gpx3 4 1>;
reset-gpios = <&gpx3 5 1>;
initial-mode = <1>;
};