Kernel-3.10.0-957.el7_spi-bus

SPI (Serial Peripheral Interface) busses

SPI busses can be described with a node for the SPI master device
and a set of child nodes for each SPI slave on the bus. For this
discussion, it is assumed that the system’s SPI controller is in
SPI master mode. This binding does not describe SPI controllers
in slave mode.

The SPI master node requires the following properties:

• #address-cells - number of cells required to define a chip select

        address on the SPI bus.
  

• #size-cells - should be zero.
• compatible - name of SPI bus controller following generic names

        recommended practice.
  

• cs-gpios - (optional) gpios chip select.
  No other properties are required in the SPI bus node. It is assumed
  that a driver for an SPI bus device will understand that it is an SPI bus.
  However, the binding does not attempt to define the specific method for
  assigning chip select numbers. Since SPI chip select configuration is
  flexible and non-standardized, it is left out of this binding with the
  assumption that board specific platform code will be used to manage
  chip selects. Individual drivers can define additional properties to
  support describing the chip select layout.

Optional property:

• num-cs : total number of chipselects

If cs-gpios is used the number of chip select will automatically increased
with max(cs-gpios > hw cs)

So if for example the controller has 2 CS lines, and the cs-gpios
property looks like this:

cs-gpios = <&gpio1 0 0> <0> <&gpio1 1 0> <&gpio1 2 0>;

Then it should be configured so that num_chipselect = 4 with the
following mapping:

cs0 : &gpio1 0 0
cs1 : native
cs2 : &gpio1 1 0
cs3 : &gpio1 2 0

SPI slave nodes must be children of the SPI master node and can
contain the following properties.

• reg - (required) chip select address of device.
• compatible - (required) name of SPI device following generic names

        recommended practice
  

• spi-max-frequency - (required) Maximum SPI clocking speed of device in Hz
• spi-cpol - (optional) Empty property indicating device requires

        inverse clock polarity (CPOL) mode
  

• spi-cpha - (optional) Empty property indicating device requires

        shifted clock phase (CPHA) mode
  

• spi-cs-high - (optional) Empty property indicating device requires

        chip select active high
  

• spi-3wire - (optional) Empty property indicating device requires

            3-wire mode.
  

If a gpio chipselect is used for the SPI slave the gpio number will be passed
via the cs_gpio

SPI example for an MPC5200 SPI bus:
spi@f00 {
#address-cells = <1>;
#size-cells = <0>;
compatible = “fsl,mpc5200b-spi”,”fsl,mpc5200-spi”;
reg = <0xf00 0x20>;
interrupts = <2 13 0 2 14 0>;
interrupt-parent = <&mpc5200_pic>;

    ethernet-switch@0 {
        compatible = "micrel,ks8995m";
        spi-max-frequency = <1000000>;
        reg = <0>;
    };

    codec@1 {
        compatible = "ti,tlv320aic26";
        spi-max-frequency = <100000>;
        reg = <1>;
    };
};