Kernel-3.10.0-957.el7_mono

           Mono(tm) Binary Kernel Support for Linux
           -----------------------------------------

To configure Linux to automatically execute Mono-based .NET binaries
(in the form of .exe files) without the need to use the mono CLR
wrapper, you can use the BINFMT_MISC kernel support.

This will allow you to execute Mono-based .NET binaries just like any
other program after you have done the following:

1. You MUST FIRST install the Mono CLR support, either by downloading
   a binary package, a source tarball or by installing from CVS. Binary
   packages for several distributions can be found at:

   http://go-mono.com/download.html

   Instructions for compiling Mono can be found at:

   http://www.go-mono.com/compiling.html

   Once the Mono CLR support has been installed, just check that
   /usr/bin/mono (which could be located elsewhere, for example
   /usr/local/bin/mono) is working.

2. You have to compile BINFMT_MISC either as a module or into
   the kernel (CONFIG_BINFMT_MISC) and set it up properly.
   If you choose to compile it as a module, you will have
   to insert it manually with modprobe/insmod, as kmod
   cannot be easily supported with binfmt_misc.
   Read the file ‘binfmt_misc.txt’ in this directory to know
   more about the configuration process.

3. Add the following entries to /etc/rc.local or similar script
   to be run at system startup:

Insert BINFMT_MISC module into the kernel

if [ ! -e /proc/sys/fs/binfmt_misc/register ]; then
/sbin/modprobe binfmt_misc
# Some distributions, like Fedora Core, perform
# the following command automatically when the
# binfmt_misc module is loaded into the kernel
# or during normal boot up (systemd-based systems).
# Thus, it is possible that the following line
# is not needed at all.
mount -t binfmt_misc none /proc/sys/fs/binfmt_misc
fi

Register support for .NET CLR binaries

if [ -e /proc/sys/fs/binfmt_misc/register ]; then
# Replace /usr/bin/mono with the correct pathname to
# the Mono CLR runtime (usually /usr/local/bin/mono
# when compiling from sources or CVS).
echo ‘:CLR:M::MZ::/usr/bin/mono:’ > /proc/sys/fs/binfmt_misc/register
else
echo “No binfmt_misc support”
exit 1
fi

4. Check that .exe binaries can be ran without the need of a
   wrapper script, simply by launching the .exe file directly
   from a command prompt, for example:

   /usr/bin/xsd.exe

   NOTE: If this fails with a permission denied error, check

     that the .exe file has execute permissions.