Kernel-3.10.0-957.el7_m25p80

• MTD SPI driver for ST M25Pxx (and similar) serial flash chips

Required properties:

• #address-cells, #size-cells : Must be present if the device has sub-nodes
  representing partitions.
• compatible : Should be the manufacturer and the name of the chip. Bear in mind

           the DT binding is not Linux-only, but in case of Linux, see the
           "m25p_ids" table in drivers/mtd/devices/m25p80.c for the list of
           supported chips.
  

• reg : Chip-Select number
• spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at

Optional properties:

• m25p,fast-read : Use the “fast read” opcode to read data from the chip instead

               of the usual "read" opcode. This opcode is not supported by
               all chips and support for it can not be detected at runtime.
               Refer to your chips' datasheet to check if this is supported
               by your chip.
  

Example:

flash: m25p80@0 {
    #address-cells = <1>;
    #size-cells = <1>;
    compatible = "spansion,m25p80";
    reg = <0>;
    spi-max-frequency = <40000000>;
    m25p,fast-read;
};