Kernel-3.10.0-957.el7_interrupts

Specifying interrupt information for devices

1. Interrupt client nodes

---

Nodes that describe devices which generate interrupts must contain an
“interrupts” property. This property must contain a list of interrupt
specifiers, one per output interrupt. The format of the interrupt specifier is
determined by the interrupt controller to which the interrupts are routed; see
section 2 below for details.

The “interrupt-parent” property is used to specify the controller to which
interrupts are routed and contains a single phandle referring to the interrupt
controller node. This property is inherited, so it may be specified in an
interrupt client node or in any of its parent nodes.

2. Interrupt controller nodes

---

A device is marked as an interrupt controller with the “interrupt-controller”
property. This is a empty, boolean property. An additional “#interrupt-cells”
property defines the number of cells needed to specify a single interrupt.

It is the responsibility of the interrupt controller’s binding to define the
length and format of the interrupt specifier. The following two variants are
commonly used:

a) one cell

The #interrupt-cells property is set to 1 and the single cell defines the
index of the interrupt within the controller.

Example:

vic: intc@10140000 {
    compatible = "arm,versatile-vic";
    interrupt-controller;
    #interrupt-cells = <1>;
    reg = <0x10140000 0x1000>;
};

sic: intc@10003000 {
    compatible = "arm,versatile-sic";
    interrupt-controller;
    #interrupt-cells = <1>;
    reg = <0x10003000 0x1000>;
    interrupt-parent = <&vic>;
    interrupts = <31>; /* Cascaded to vic */
};

b) two cells

The #interrupt-cells property is set to 2 and the first cell defines the
index of the interrupt within the controller, while the second cell is used
to specify any of the following flags:
- bits[3:0] trigger type and level flags
1 = low-to-high edge triggered
2 = high-to-low edge triggered
4 = active high level-sensitive
8 = active low level-sensitive

Example:

i2c@7000c000 {
    gpioext: gpio-adnp@41 {
        compatible = "ad,gpio-adnp";
        reg = <0x41>;

        interrupt-parent = <&gpio>;
        interrupts = <160 1>;

        gpio-controller;
        #gpio-cells = <1>;

        interrupt-controller;
        #interrupt-cells = <2>;

        nr-gpios = <64>;
    };

    sx8634@2b {
        compatible = "smtc,sx8634";
        reg = <0x2b>;

        interrupt-parent = <&gpioext>;
        interrupts = <3 0x8>;

        #address-cells = <1>;
        #size-cells = <0>;

        threshold = <0x40>;
        sensitivity = <7>;
    };
};