Transparent proxy support
This feature adds Linux 2.2-like transparent proxy support to current kernels.
To use it, enable NETFILTER_TPROXY, the socket match and the TPROXY target in
your kernel config. You will need policy routing too, so be sure to enable that
as well.
The idea is that you identify packets with destination address matching a local
socket on your box, set the packet mark to a certain value, and then match on that
value using policy routing to have those packets delivered locally:
iptables -t mangle -N DIVERT
iptables -t mangle -A PREROUTING -p tcp -m socket -j DIVERT
iptables -t mangle -A DIVERT -j MARK –set-mark 1
iptables -t mangle -A DIVERT -j ACCEPT
ip rule add fwmark 1 lookup 100
ip route add local 0.0.0.0/0 dev lo table 100
Because of certain restrictions in the IPv4 routing output code you’ll have to
modify your application to allow it to send datagrams from non-local IP
addresses. All you have to do is enable the (SOL_IP, IP_TRANSPARENT) socket
option before calling bind:
fd = socket(AF_INET, SOCK_STREAM, 0);
/* - 8< -/
int value = 1;
setsockopt(fd, SOL_IP, IP_TRANSPARENT, &value, sizeof(value));
/ - 8< -*/
name.sin_family = AF_INET;
name.sin_port = htons(0xCAFE);
name.sin_addr.s_addr = htonl(0xDEADBEEF);
bind(fd, &name, sizeof(name));
A trivial patch for netcat is available here:
http://people.netfilter.org/hidden/tproxy/netcat-ip_transparent-support.patch
Transparent proxying often involves “intercepting” traffic on a router. This is
usually done with the iptables REDIRECT target; however, there are serious
limitations of that method. One of the major issues is that it actually
modifies the packets to change the destination address – which might not be
acceptable in certain situations. (Think of proxying UDP for example: you won’t
be able to find out the original destination address. Even in case of TCP
getting the original destination address is racy.)
The ‘TPROXY’ target provides similar functionality without relying on NAT. Simply
add rules like this to the iptables ruleset above:
iptables -t mangle -A PREROUTING -p tcp –dport 80 -j TPROXY \
–tproxy-mark 0x1/0x1 –on-port 50080
Note that for this to work you’ll have to modify the proxy to enable (SOL_IP,
IP_TRANSPARENT) for the listening socket.
To use tproxy you’ll need to have the ‘socket’ and ‘TPROXY’ modules
compiled for iptables. A patched version of iptables is available
here: http://git.balabit.hu/?p=bazsi/iptables-tproxy.git
4.1. Squid
Squid 3.HEAD has support built-in. To use it, pass
‘–enable-linux-netfilter’ to configure and set the ‘tproxy’ option on
the HTTP listener you redirect traffic to with the TPROXY iptables
target.
For more information please consult the following page on the Squid
wiki: http://wiki.squid-cache.org/Features/Tproxy4
