Binding for the AXS10x reset controller
This binding describes the ARC AXS10x boards custom IP-block which allows
to control reset signals of selected peripherals. For example DW GMAC, etc…
This block is controlled via memory-mapped register (AKA CREG) which
represents up-to 32 reset lines.
As of today only the following lines are used:
- DW GMAC - line 5
This binding uses the common reset binding[1].
[1] Documentation/devicetree/bindings/reset/reset.txt
Required properties:
- compatible: should be “snps,axs10x-reset”.
- reg: should always contain pair address - length: for creg reset
bits register. - #reset-cells: from common reset binding; Should always be set to 1.
Example:
reset: reset-controller@11220 {
compatible = “snps,axs10x-reset”;
#reset-cells = <1>;
reg = <0x11220 0x4>;
};
Specifying reset lines connected to IP modules:
ethernet@…. {
….
resets = <&reset 5>;
….
};
