Kernel-4.18.0-80.el8_smsc_ece1099

=================================================
Msc Keyboard Scan Expansion/GPIO Expansion device
=================================================

What is smsc-ece1099?

The ECE1099 is a 40-Pin 3.3V Keyboard Scan Expansion
or GPIO Expansion device. The device supports a keyboard
scan matrix of 23x8. The device is connected to a Master
via the SMSC BC-Link interface or via the SMBus.
Keypad scan Input(KSI) and Keypad Scan Output(KSO) signals
are multiplexed with GPIOs.

Interrupt generation

Interrupts can be generated by an edge detection on a GPIO
pin or an edge detection on one of the bus interface pins.
Interrupts can also be detected on the keyboard scan interface.
The bus interrupt pin (BC_INT# or SMBUS_INT#) is asserted if
any bit in one of the Interrupt Status registers is 1 and
the corresponding Interrupt Mask bit is also 1.

In order for software to determine which device is the source
of an interrupt, it should first read the Group Interrupt Status Register
to determine which Status register group is a source for the interrupt.
Software should read both the Status register and the associated Mask register,
then AND the two values together. Bits that are 1 in the result of the AND
are active interrupts. Software clears an interrupt by writing a 1 to the
corresponding bit in the Status register.

Communication Protocol

• SMbus slave Interface
  The host processor communicates with the ECE1099 device
  through a series of read/write registers via the SMBus
  interface. SMBus is a serial communication protocol between
  a computer host and its peripheral devices. The SMBus data
  rate is 10KHz minimum to 400 KHz maximum

• Slave Bus Interface
  The ECE1099 device SMBus implementation is a subset of the
  SMBus interface to the host. The device is a slave-only SMBus device.
  The implementation in the device is a subset of SMBus since it
  only supports four protocols.

  The Write Byte, Read Byte, Send Byte, and Receive Byte protocols are the
  only valid SMBus protocols for the device.

• BC-LinkTM Interface
  The BC-Link is a proprietary bus that allows communication
  between a Master device and a Companion device. The Master
  device uses this serial bus to read and write registers
  located on the Companion device. The bus comprises three signals,
  BC_CLK, BC_DAT and BC_INT#. The Master device always provides the
  clock, BC_CLK, and the Companion device is the source for an
  independent asynchronous interrupt signal, BC_INT#. The ECE1099
  supports BC-Link speeds up to 24MHz.