Kernel-4.18.0-80.el8_renesas_usbhs

Renesas Electronics USBHS driver

Required properties:

• compatible: Must contain one or more of the following:

  • “renesas,usbhs-r8a7743” for r8a7743 (RZ/G1M) compatible device
  • “renesas,usbhs-r8a7745” for r8a7745 (RZ/G1E) compatible device
  • “renesas,usbhs-r8a7790” for r8a7790 (R-Car H2) compatible device
  • “renesas,usbhs-r8a7791” for r8a7791 (R-Car M2-W) compatible device
  • “renesas,usbhs-r8a7792” for r8a7792 (R-Car V2H) compatible device
  • “renesas,usbhs-r8a7793” for r8a7793 (R-Car M2-N) compatible device
  • “renesas,usbhs-r8a7794” for r8a7794 (R-Car E2) compatible device
  • “renesas,usbhs-r8a7795” for r8a7795 (R-Car H3) compatible device
  • “renesas,usbhs-r8a7796” for r8a7796 (R-Car M3-W) compatible device
  • “renesas,usbhs-r8a77965” for r8a77965 (R-Car M3-N) compatible device
  • “renesas,usbhs-r8a77995” for r8a77995 (R-Car D3) compatible device
  • “renesas,usbhs-r7s72100” for r7s72100 (RZ/A1) compatible device
  • “renesas,rcar-gen2-usbhs” for R-Car Gen2 or RZ/G1 compatible devices
  • “renesas,rcar-gen3-usbhs” for R-Car Gen3 compatible device
  • “renesas,rza1-usbhs” for RZ/A1 compatible device

  When compatible with the generic version, nodes must list the
  SoC-specific version corresponding to the platform first followed
  by the generic version.

• reg: Base address and length of the register for the USBHS

• interrupts: Interrupt specifier for the USBHS

• clocks: A list of phandle + clock specifier pairs

Optional properties:

• renesas,buswait: Integer to use BUSWAIT register
• renesas,enable-gpio: A gpio specifier to check GPIO determining if USB

       function should be enabled
  

• phys: phandle + phy specifier pair
• phy-names: must be “usb”
• dmas: Must contain a list of references to DMA specifiers.
• dma-names : named “ch%d”, where %d is the channel number ranging from zero

          to the number of channels (DnFIFOs) minus one.
  

Example:
usbhs: usb@e6590000 {
compatible = “renesas,usbhs-r8a7790”, “renesas,rcar-gen2-usbhs”;
reg = <0 0xe6590000 0 0x100>;
interrupts = <0 107 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&mstp7_clks R8A7790_CLK_HSUSB>;
};