Kernel-4.18.0-80.el8_partition

Flash partitions in device tree

Flash devices can be partitioned into one or more functional ranges (e.g. “boot
code”, “nvram”, “kernel”).

Different devices may be partitioned in a different ways. Some may use a fixed
flash layout set at production time. Some may use on-flash table that describes
the geometry and naming/purpose of each functional region. It is also possible
to see these methods mixed.

To assist system software in locating partitions, we allow describing which
method is used for a given flash device. To describe the method there should be
a subnode of the flash device that is named ‘partitions’. It must have a
‘compatible’ property, which is used to identify the method to use.

Available bindings are listed in the “partitions” subdirectory.

Fixed Partitions

Partitions can be represented by sub-nodes of a flash device. This can be used
on platforms which have strong conventions about which portions of a flash are
used for what purposes, but which don’t use an on-flash partition table such
as RedBoot.

The partition table should be a subnode of the flash node and should be named
‘partitions’. This node should have the following property:

• compatible : (required) must be “fixed-partitions”
  Partitions are then defined in subnodes of the partitions node.

For backwards compatibility partitions as direct subnodes of the flash device are
supported. This use is discouraged.
NOTE: also for backwards compatibility, direct subnodes that have a compatible
string are not considered partitions, as they may be used for other bindings.

#address-cells & #size-cells must both be present in the partitions subnode of the
flash device. There are two valid values for both:
<1>: for partitions that require a single 32-bit cell to represent their
size/address (aka the value is below 4 GiB)
<2>: for partitions that require two 32-bit cells to represent their
size/address (aka the value is 4 GiB or greater).

Required properties:

• reg : The partition’s offset and size within the flash

Optional properties:

• label : The label / name for this partition. If omitted, the label is taken
  from the node name (excluding the unit address).
• read-only : This parameter, if present, is a hint to Linux that this
  partition should only be mounted read-only. This is usually used for flash
  partitions containing early-boot firmware images or data which should not be
  clobbered.
• lock : Do not unlock the partition at initialization time (not supported on
  all devices)

Examples:

flash@0 {
partitions {
compatible = “fixed-partitions”;
#address-cells = <1>;
#size-cells = <1>;

    partition@0 {
        label = "u-boot";
        reg = <0x0000000 0x100000>;
        read-only;
    };

    uimage@100000 {
        reg = <0x0100000 0x200000>;
    };
};

};

flash@1 {
partitions {
compatible = “fixed-partitions”;
#address-cells = <1>;
#size-cells = <2>;

    /* a 4 GiB partition */
    partition@0 {
        label = "filesystem";
        reg = <0x00000000 0x1 0x00000000>;
    };
};

};

flash@2 {
partitions {
compatible = “fixed-partitions”;
#address-cells = <2>;
#size-cells = <2>;

    /* an 8 GiB partition */
    partition@0 {
        label = "filesystem #1";
        reg = <0x0 0x00000000 0x2 0x00000000>;
    };

    /* a 4 GiB partition */
    partition@200000000 {
        label = "filesystem #2";
        reg = <0x2 0x00000000 0x1 0x00000000>;
    };
};

};