Kernel-4.18.0-80.el8_faraday,tve200

• Faraday TV Encoder TVE200

Required properties:

• compatible: must be one of:
  “faraday,tve200”
  “cortina,gemini-tvc”, “faraday,tve200”

• reg: base address and size of the control registers block

• interrupts: contains an interrupt specifier for the interrupt
  line from the TVE200

• clock-names: should contain “PCLK” for the clock line clocking the
  silicon and “TVE” for the 27MHz clock to the video driver

• clocks: contains phandle and clock specifier pairs for the entries
  in the clock-names property. See
  Documentation/devicetree/bindings/clock/clock-bindings.txt

Optional properties:

• resets: contains the reset line phandle for the block

Required sub-nodes:

• port: describes LCD panel signals, following the common binding
  for video transmitter interfaces; see
  Documentation/devicetree/bindings/media/video-interfaces.txt
  This port should have the properties:
  reg = <0>;
  It should have one endpoint connected to a remote endpoint where
  the display is connected.

Example:

display-controller@6a000000 {
#address-cells = <1>;
#size-cells = <0>;
compatible = “faraday,tve200”;
reg = <0x6a000000 0x1000>;
interrupts = <13 IRQ_TYPE_EDGE_RISING>;
resets = <&syscon GEMINI_RESET_TVC>;
clocks = <&syscon GEMINI_CLK_GATE_TVC>,
<&syscon GEMINI_CLK_TVC>;
clock-names = “PCLK”, “TVE”;

port@0 {
    reg = <0>;
    display_out: endpoint {
        remote-endpoint = <&panel_in>;
    };
};

};