Kernel-3.10.0-957.el7_fsl-upm-nan

Freescale Localbus UPM programmed to work with NAND flash

Required properties:

• compatible : “fsl,upm-nand”.
• reg : should specify localbus chip select and size used for the chip.
• fsl,upm-addr-offset : UPM pattern offset for the address latch.
• fsl,upm-cmd-offset : UPM pattern offset for the command latch.

Optional properties:

• fsl,upm-wait-flags : add chip-dependent short delays after running the
  UPM pattern (0x1), after writing a data byte (0x2) or after
  writing out a buffer (0x4).
• fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
  The corresponding address lines are used to select the chip.
• gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
  (R/B#). For multi-chip devices, “n” GPIO definitions are required
  according to the number of chips.
• chip-delay : chip dependent delay for transferring data from array to
  read registers (tR). Required if property “gpios” is not used
  (R/B# pins not connected).

Each flash chip described may optionally contain additional sub-nodes
describing partitions of the address space. See partition.txt for more
detail.

Examples:

upm@1,0 {
compatible = “fsl,upm-nand”;
reg = <1 0 1>;
fsl,upm-addr-offset = <16>;
fsl,upm-cmd-offset = <8>;
gpios = <&qe_pio_e 18 0>;

flash {
    #address-cells = <1>;
    #size-cells = <1>;
    compatible = "...";

    partition@0 {
        ...
    };
};

};

upm@3,0 {
#address-cells = <0>;
#size-cells = <0>;
compatible = “tqc,tqm8548-upm-nand”, “fsl,upm-nand”;
reg = <3 0x0 0x800>;
fsl,upm-addr-offset = <0x10>;
fsl,upm-cmd-offset = <0x08>;
/* Multi-chip NAND device */
fsl,upm-addr-line-cs-offsets = <0x0 0x200>;
fsl,upm-wait-flags = <0x5>;
chip-delay = <25>; // in micro-seconds

nand@0 {
    #address-cells = <1>;
    #size-cells = <1>;

    partition@0 {
            label = "fs";
            reg = <0x00000000 0x10000000>;
    };
};

};