Freescale’s NAND flash controller (NFC)
This variant of the Freescale NAND flash controller (NFC) can be found on
Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70.
Required properties:
compatible: Should be set to “fsl,vf610-nfc”.
reg: address range of the NFC.
interrupts: interrupt of the NFC.
#address-cells: shall be set to 1. Encode the nand CS.
#size-cells : shall be set to 0.
assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>;
assigned-clock-rates: The NAND bus timing is derived from this clock
rate and should not exceed maximum timing for any NAND memory chip
in a board stuffing. Typical NAND memory timings derived from this
clock are found in the SoC hardware reference manual. Furthermore,
there might be restrictions on maximum rates when using hardware ECC.#address-cells, #size-cells : Must be present if the device has sub-nodes
representing partitions.
Required children nodes:
Children nodes represent the available nand chips. Currently the driver can
only handle one NAND chip.
Required properties:
- compatible: Should be set to “fsl,vf610-nfc-cs”.
- nand-bus-width: see nand.txt
- nand-ecc-mode: see nand.txt
Required properties for hardware ECC:
- nand-ecc-strength: supported strengths are 24 and 32 bit (see nand.txt)
- nand-ecc-step-size: step size equals page size, currently only 2k pages are
supported - nand-on-flash-bbt: see nand.txt
Example:
nfc: nand@400e0000 {
compatible = "fsl,vf610-nfc";
#address-cells = <1>;
#size-cells = <0>;
reg = <0x400e0000 0x4000>;
interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clks VF610_CLK_NFC>;
clock-names = "nfc";
assigned-clocks = <&clks VF610_CLK_NFC>;
assigned-clock-rates = <33000000>;
nand@0 {
compatible = "fsl,vf610-nfc-nandcs";
reg = <0>;
nand-bus-width = <8>;
nand-ecc-mode = "hw";
nand-ecc-strength = <32>;
nand-ecc-step-size = <2048>;
nand-on-flash-bbt;
};
};
