- Renesas R-Car generation 2 USB PHY
This file provides information on what the device node for the R-Car generation
2 USB PHY contains.
Required properties:
compatible: “renesas,usb-phy-r8a7743” if the device is a part of R8A7743 SoC.
"renesas,usb-phy-r8a7745" if the device is a part of R8A7745 SoC. "renesas,usb-phy-r8a7790" if the device is a part of R8A7790 SoC. "renesas,usb-phy-r8a7791" if the device is a part of R8A7791 SoC. "renesas,usb-phy-r8a7794" if the device is a part of R8A7794 SoC. "renesas,rcar-gen2-usb-phy" for a generic R-Car Gen2 or RZ/G1 compatible device. When compatible with the generic version, nodes must list the SoC-specific version corresponding to the platform first followed by the generic version.reg: offset and length of the register block.
#address-cells: number of address cells for the USB channel subnodes, must
be <1>.#size-cells: number of size cells for the USB channel subnodes, must be <0>.
clocks: clock phandle and specifier pair.
clock-names: string, clock input name, must be “usbhs”.
The USB PHY device tree node should have the subnodes corresponding to the USB
channels. These subnodes must contain the following properties:
- reg: the USB controller selector; see the table below for the values.
- #phy-cells: see phy-bindings.txt in the same directory, must be <1>.
The phandle’s argument in the PHY specifier is the USB controller selector for
the USB channel; see the selector meanings below:
+———–+—————+—————+
|\ Selector | | |
- ——— + 0 | 1 |
| Channel | | | - ———–+—————+—————+
| 0 | PCI EHCI/OHCI | HS-USB |
| 2 | PCI EHCI/OHCI | xHCI | - ———–+—————+—————+
Example (Lager board):
usb-phy@e6590100 {
compatible = "renesas,usb-phy-r8a7790", "renesas,rcar-gen2-usb-phy";
reg = <0 0xe6590100 0 0x100>;
#address-cells = <1>;
#size-cells = <0>;
clocks = <&mstp7_clks R8A7790_CLK_HSUSB>;
clock-names = "usbhs";
usb-channel@0 {
reg = <0>;
#phy-cells = <1>;
};
usb-channel@2 {
reg = <2>;
#phy-cells = <1>;
};
};
