Kernel-4.18.0-80.el8_adi,adau1701

Analog Devices ADAU1701

Required properties:

• compatible: Should contain “adi,adau1701”
• reg: The i2c address. Value depends on the state of ADDR0

       and ADDR1, as wired in hardware.
  

Optional properties:

• reset-gpio: A GPIO spec to define which pin is connected to the

       chip's !RESET pin. If specified, the driver will
       assert a hardware reset at probe time.
  

• adi,pll-mode-gpios: An array of two GPIO specs to describe the GPIOs

       the ADAU's PLL config pins are connected to.
       The state of the pins are set according to the
       configured clock divider on ASoC side before the
       firmware is loaded.
  

• adi,pin-config: An array of 12 numerical values selecting one of the

       pin configurations as described in the datasheet,
       table 53. Note that the value of this property has
       to be prefixed with '/bits/ 8'.
  

• avdd-supply: Power supply for AVDD, providing 3.3V
• dvdd-supply: Power supply for DVDD, providing 3.3V

Examples:

i2c_bus {
    adau1701@34 {
        compatible = "adi,adau1701";
        reg = <0x34>;
        reset-gpio = <&gpio 23 0>;
        avdd-supply = <&vdd_3v3_reg>;
        dvdd-supply = <&vdd_3v3_reg>;
        adi,pll-mode-gpios = <&gpio 24 0 &gpio 25 0>;
        adi,pin-config = /bits/ 8 <0x4 0x7 0x5 0x5 0x4 0x4
                                               0x4 0x4 0x4 0x4 0x4 0x4>;
    };
};